浦东江西水泥车库地坪多少钱一平方

浦东江西水泥车库地坪多少钱一平方 塑胶篮球场的首要资料:双组份聚氨酯浆料,单组份聚氨酯胶水,PU颗粒,硅PU颗粒,EDPM颗粒,黑色废轮胎颗粒等。 一,首要查看基础层的平整度,对凹凸部位进行找平(如水泥砼基础需酸洗)。 二,底胶铺装:铺装底胶以前先将地基基础扫除清洁,准备好施工用的东西。 (1)依照工艺要求测量出施工线的方位,放好施工线。    (2)铺装时由场所一侧开端,按场所宽度一次性刮胶。    环氧地坪开裂处理对策:联络:4oo-o7o9-91o1.面漆硬度不宜太高,应留神涂料配方中涂膜的柔韧性;2.应在头道漆充沛干透后再涂二道漆;3.经过实验处理涂层的配套性,一般使底漆涂层4.和面漆涂层的硬度,伸缩性挨近;5.环氧地坪面漆的蒸发组分不宜过多;6.环氧地坪施工中每道涂膜不宜过厚;7.应留神催干剂的用量和调配;8.应防止在有污气的环境中施工和长期应用
;9.色漆应充沛拌和平均后再施工;10.留神涂料的应用
环境温度; (3)刮胶时速度平均,及时对露底,洼陷,凸起处进行补胶或刮平。    (4)成胶后,对全场进行查看,以包管面胶铺装的厚度。    三,面胶的摊铺:    (1)刮胶时尽量缩短每一桶胶液的间隔时间,使成胶速度平均共同; (2)时间调查胶面的厚度; (3)刮面胶,在面胶未固化前,撒上塑胶颗粒,待其完全固化后,将残存面胶粒扫除清洁; (4)喷胶,包管颗粒不掉落。   Main material of plastic basketball court: two-component polyurethane slurry, one component polyurethane glue, Pu particles, silicon Pu particles, EDPM particles, black waste tyre particles.Firstly, check the flatness of the base layer, leveling of the concavo convex parts (such as cement concrete foundation for pickling).Two, the bottom of plastic paving: before paving the foundation of the foundation to clean the ground, ready to use the tool for construction.(1) according to the technical requirements of the construction line measurement of the location, put a good construction line.(2) starting from the side of site survey, according to the width of the site once frictioning. Epoxy floor cracking treatment measures: Contact: 4oo-o7o9-91o1 finish should not be too high hardness, should pay attention to film coating formulation flexibility;2 in the first coating fully dry and then coated with two coats of paint;3 matching through the test solution of coating, the general primer coating 4 and finish coating hardness, elasticity approach;5 volatile epoxy topcoat should not be too much;6 epoxy floor construction in each film should not be too thick;7 should pay attention to the amount of drying agent and collocation;8 should be avoided in the environment with waste gas construction and long time use;9 color paint should be fully mixed after the construction of uniform;10 pay attention to the use of paint environment temperature;(3) the spreading speed is even, in time for the show, concave and convex of glue or scraping.(4) after the adhesive, the whole audience to check, to ensure that the thickness of the surface adhesive pavement.Three, the surface of the rubber paving:(1) the time interval frictioning when you try to reduce every barrel of glue, the gelation rate is uniform;(2) the thickness of the adhesive surface;(3) scraping rubber surface, in the rubber surface not before curing, sprinkle on plastic granules, until fully cured, surplus particles cleaned.(4) spraying, to ensure that the particle does not fall off.

此条目发表在金宝搏登录分类目录。将固定链接加入收藏夹。